Installation Environment
Kyocera Recommends selecting the Location for the printer
as follows:
1. Room Temperatur
e range: 50 to 90.5°F (10°C to 32.5°C)
2. Humidity Level: 10 to 80%
3. Power:
Avoid the followin
g locations when selecting a site for the
machine. Adverse environmental conditions may affect the
image quality.
+ Avoid locations ne
ar a window or with exposure to
direct sunlight.
+ Avoid locations with vibrations.
+ Avoid locations with rapid temperature fluctuations.
+ Avoid locations with direct exposure to hot or cold air.
+ Avoid poorly ventilated locations.
recommended installation space
Step1 Setting up the machine
1. Open the Box. Remove the Packing material, cushioning,
plastic bag, the power cord, Toner Cartridge, etc.
2. Hold the machine by grasping both sides.
3. Remove the Tape ① as shown. ② Open the Top Cover.
4. Remove
the tape and packing ③. Grab the Drum Unit D ④
as shown and lift it from the Printer.⑤ Place it on a sheet
of paper on a flat surface.
Note: The drum unit is sensitive to light. Never expose the
drum unit to light for more than five minutes.
5. Open the front
Paper Feeder ⑥ and remove the packing
sheet that protects the drum ⑦.
6. Reinstall t
he Drum Unit D as shown ⑧ and push to lock it in
place.
7. Remove the toner cartridge from the bag ⑨, shake it 5
times to loosen toner, ⑩ Unsnap the protective cover on
both sides and remove the cover as shown.
4
3
5
6
7
8
9
10
2021.10 3V2YV5611001
PA2000w/PA2000 Setup
A dedicated 120VAC 60Hz 15A outlet
A dedicated 200-240VAC 50/60Hz 15A outlet
200
mm
(8")
200
mm
(8")
200
mm
(8")
250 mm
(10")
400 mm
(
15.75"
)
120 V Specification Model:
230 V Specification Model:
2
1
D
D
To Next Page
Need help?
General