Need help?Do you have a question about the Kyosho Advance and is the answer not in the manual?
General| Brand | Kyosho |
|---|---|
| Model | Advance |
| Category | Motorized Toy Car |
| Language | English |
Lists essential components and tools required for the kit.
Details the required radio control system for operation.
Lists tools included and not included with the Advance kit.
Components necessary for operating the model after assembly.
Important preliminary checks and warnings before starting assembly.
Steps to install the front damper stay onto the main chassis.
Guide for mounting the arm axle assembly.
Steps for attaching the servo saver mechanism.
Detailed steps for building the rear chassis structure.
Attaching the left and right side plates to the chassis.
Mounting the main gearbox onto the chassis assembly.
Securing the gearbox assembly to the chassis.
Procedure for properly filling shock absorbers with oil.
Steps to attach damper balls to suspension arms.
Attaching the rear axle assembly to the chassis.
Information on upgrading bushings to ball bearings for improved performance.
Mounting the rear suspension components.
Building the knuckle arm assemblies for steering.
Finalizing the knuckle arm assembly and mounting it.
Attaching the lower suspension arms.
Connecting the tie rods for steering alignment.
Attaching the protective roll bar.
Preparing the plate that holds the radio equipment.
Securing the fuel tank in its position.
Final mounting of the radio plate and components.
Building the mechanism for the starter gear.
Attaching the flywheel to the engine.
Correctly fitting the clutch shoes into the mechanism.
Mounting the clutch bell assembly.
Securing the engine to the chassis and ensuring proper alignment.
Connecting the glow plug wire and fuel line to the engine.
Connecting the battery terminal to the chassis.
Modifying and preparing the radio box for equipment installation.
Placing the receiver and battery pack in the radio box.
Mounting the tires onto the wheels and attaching them to the car.
Connecting the steering linkage from servo to wheels.
Setting up the throttle and brake control linkages.
Steps for preparing and painting the clear body shell.
Attaching the headlight assemblies to the roll cage.
Building and mounting the air cleaner and muffler components.
List of accessories and supplies needed for operation.
Detailed procedure for starting the engine using the Zip Starter.
Steps for fueling and connecting the glow plug.
Fine-tuning engine performance after initial start.
Causes and prevention of engine overheating.
Common engine problems and their solutions.
Procedure for lubricating the gearbox for smooth operation.
How to set toe-in for proper steering alignment.
Reference list of all parts with their corresponding key numbers.
Information on ordering replacement parts via convenient parts packs.
To Next Page