EasyManua.ls Logo

Kyosho EP concept - Troubleshooting Guide; Problem, Cause, and Remedy

Kyosho EP concept
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22
故障?と思う前に
Troubleshooting
□ホバリングピッチを8°に調整する。
メインローターが回らない。
配線の接続違い。
アンプの調整不良。 □プロポの説明書を読み、再調整する。
充電不足。 □充電器の説明書を読み、再度放電からおこなう。
□モーター・アンプ・ニカドバッテリーの
 接続を再確認する。
モーターの回転が悪い。
回転しない。
モーター内のコミュテーターの汚れ。
ブラシとコミュテーターの接触が悪い。 □一度外してつけ直す。
ブラシの寿命。 □ブラシを交換する。
モーターの寿命。 □モーターを交換する。
□ブラシを交換する。
トラッキングが合わない。
ピッチ角が合っていない。
スピンドルシャフトの曲がり。 □スピンドルシャフトを交換。
メインローターグリップ部の
ベアリングの劣化。
□ベアリングを交換。
メインローターバランスが合って
いない。
□バランス調整。
P16 トラッキング調整。
振動が大きい。
メインマストの曲がり。
アウトプットシャフトの曲がり。 □アウトプットシャフトを交換。
メインローターバランスが合って
いない。
□バランス調整。
メインローター固定ビスの締め過ぎ。 □ローターが手で動く程度に締めなおす。
□メインマストを交換。
ラダーが効かない。
ベルトがたるんでいる。
テールローターグリップの向きが逆。 □向きを確認する。
テールローターが逆回転している。 □ベルトのねじる向きを逆にする。
ジャイロの動作方向が逆。 □プロポの説明書を読み、確認する。
□フレームのテールブーム固定ビスが
 緩んでないか、確認する。
Problem
Cause
Does not lift off.
Pitch on main rotor too small.
Electric motor running bad. Read "Electric motor rotates badly".
Remedy
Set hover pitch to 8û.
Electric motor rotates badly.
Or, does not rotate.
Insufficient brush & commutator contact.
Worn brushes. Replace brushes.
Motor lifespan over. Replace motor.
Remove and reinstall.
Dirty commutator. Replace brushes.
Main rotor does not rotate.
Incorrect radio connection & installation.
Electronic speed controller not set. Read radio explanations and reset.
Ni-Cd battery not charged. Read charger unit explanations and try charge
again.
Are electric motor, electronic speed controller
and Ni-Cd battery correctly connected?
Main rotor blades track
differently.
Pitch on main rotor different.
Bent spindle shaft. Replace spindle shaft.
Worn ball bearings in main
rotor grips.
Replace ball bearings.
Unbalanced main rotor. Balance out (with tracking tape).
Main rotor blade installation reverse. Reinstall blades.
Make pitch same.
Strong vibration
Bent main mast.
Bent output shaft. Replace output shaft.
Unbalanced main rotor.
Overtight screws attaching
main rotor blades.
Retighten so blades have a little play in grips.
Replace main mast.
No rudder control.
Slack belt.
Tail rotor grip installation reverse. Check their direction.
Tail rotor rotates into opposite direction. Twist belt into opposite direction.
Reverse gyro operation. Read radio instruction manual and check.
Are screws attaching tail boom to frame loose?
P13
22
P14
26
P14
25
メインローターの取付け向きが逆。 □付けなおす。P14
25
P20
P7 5
P8 9
P13
22
P14
P16
26
P14
25
Balance out (with tracking tape).
P14
25
P14
25
P7 5
P8
P20
9

Other manuals for Kyosho EP concept

Related product manuals