L-ACOUSTICS MTD Manual V1.2 30-11-04 59
8.2 MTD108LLCa SPECIFICATIONS
Technical
Inputs Electronically balanced 10 kΩ input (pin 2 hot)
Outputs Electronically balanced 50 Ω output (pin 2 hot)
Input Headroom +20 dBV
Nominal Gain at 200 Hz 0 dB (unity gain)
Signal to Noise > 84 dB
Dynamic Range > 104 dB
THD <0.01% (20 to 20k Hz @ 0 dBV)
Bandpass/Equalization Filters
3 modes: MONITOR = 80 Hz (BW12 HP)
FRONT = 50 Hz (LR24 HP+EQ)
XOVER = 125 Hz (HP)
Low-pass: 20 kHz
SB115 Subwoofer: 40 - 125 Hz (LR 24 HP/LP + EQ)
Speaker Protection RMS limiter & peak limiter
Front & Rear Panel
Indicators Signal: green LED for each section
Control: yellow LED for each section
Front Panel Controls AC power, MODE select, SUB/SUM select
Rear Panel Control IN PHASE/OUT PHASE (MONO output polarity)
Front Panel Connectors Channel 1, 2 XLR inputs, parallel loop through
Loudspeaker: 2x 4-pin Neutrik speakon
Rear Panel Connectors Sense Return: 4-pin Neutrik speakon
MONO, Channel 1, 2 XLR line outputs
Power Requirement 100 V - 240 V 50/60 Hz
Power Consumption 15 W
Physical
Finish Black anodized front panel, white serigraphy
Net Dimensions 483 x 44 x 305 mm
19 x 1.75 x 12.0 in
Net Weight 3.75 kg 8.3 lbs
Shipping Dimensions 505 x 80 x 415 mm
19.9 x 3.1 x 16.3 in
Shipping Weight 4.8 kg 10.6 lbs
To Next Page