F. Mute
Press the footswitch to engage the mute for both the
XLR and ¼” outputs. The orange LED will light up when
the Session DI is muted. Press the footswitch again to
un-mute your signal.
G. Notch
The notch lter is designed to help control feedback. If
your guitar begins to feedback, slowly turn the notch
control clockwise. The oending frequency will stop
instantly when the notch is in the proper position.
H. Phase
Press this button to invert the phase. Usually, one phase
will provide the best sound and feedback resistance.
Phase is relative to your position on the stage so we
recommend trying both phases each time you set up.
I. Volume
The master volume aects both the ¼” and XLR outputs.
J. ¼” output
The ¼” output is an unbalanced line level output. You
can plug into any amp or device that has a ¼” input. For
best results we recommend a full-range PA or high
quality acoustic amplier.
K. XLR output
The XLR, or DI output (located on the top), is a balanced
output for connecting to a mixing desk with a standard
XLR cable.
To Next Page
Loading...
Need help?
General
