Page | 6Wi-Fi Projection Alarm Clock
Optional Extra Sensors: Up to 4 additional Thermo-Hygro, Wind Speed, Rain, Water Leak or any
combination of these sensors can read to the EXTRA SENSOR area of your display. Simply press and
release the EXTRA SENSOR button to view these sensors.
Purchase Extra Sensors: For additional sensors to read to your alarm clock or to the app visit the PARTS
TAB at: bit.ly/C82929
Note: Not all sensors will read to the alarm clock. Be sure to check the chart to see if a sensor can read to
the app only, or both alarm clock (extra sesnor area) and app.
PURCHASE AND ADD SENSORS
Add Extra Sensors to your alarm clock:
1. Hold the EXTRA SENSOR button 3 seconds, to add a sensor to the alarm clock.
2. Install batteries in the sensor, and if the sensor has a TX button, press the TX button to force a signal.
3. Allow up to 3 minutes to view sensor and ID on alarm clock.
Note: Once sensor is found the search will stop. Sensor, ID, and type will show for 3 seconds then return
to normal display.
4. Scan sensor bar code ID so it will read in the La Crosse View app.
5. Added sensors will be available for display in Extra Sensor area of alarm clock.
AA
+
-
AA
+
-
Sensor Barcode ID
Insert Batteries
TX Button
Delete Extra Sensors from your alarm clock:
1. Press and release the EXTRA SENSOR button until you see the sensor and ID you wish to delete.
2. Hold the MINUS (-) button for 3 seconds to delete this sensor. The sensor readings and ID will show
dashes.
3. Sensor will no longer show in the Extra Sensor area.
IN
MOON PHASE
COMFORT
Basic alarm clock readings Basic alarm clock readings with Water Leak sensor.
IN
MOON PHASE
COMFORT
EXTRA
SENSOR
To Next Page
Loading...
Need help?
General
