10 | Page
HOW DO I MANUALLY SET THE TIME?
When operating as a standalone station, you can manually adjust your station’s settings:
1. Hold the SET button 2 seconds to enter settings mode.
2. Press the + or - button to adjust the flashing values.
3. Hold the + or - button to adjust quickly.
4. Press the SET button to confirm adjustments and move to the next item.
5. Press the LIGHT button at any time to exit.
Settings Order:
• Language (English, Spanish, French, German)
• Greeting HELLO SETUP TIME
• 12HR/24HR
• Hour
• Minute
• Year
• Month
• Date
• Fahrenheit/Celsius
• Pressure: InHg / hPa
• Pressure number setting
• Wind Speed MPH or KMH
• Wind Direction Letters or Degrees
• THANK YOU
Note: Units in the settings menu reflect how sensors will show on the station and which units are
shown in Data Stream. This includes the Extra sensors. I.E. When Fahrenheit is selected-
Fahrenheit on station and in Data Stream.
Full Program Menu:
1. Hold the SET button for 2 seconds to enter setting mode. ENGLISH will show. Press the + or
- button to change to another language (Español, Français or Deutsch).
2. Press SET button and the Greeting (HELLO SETUP TIME) will show for two seconds, then
automatically move to 12/24 hour time. 12/24 HOUR FORMAT will show. 12HR flashes. Press
the + or - button to turn select 24 hour time format.
3. Press SET to confirm and move to the hour. HOUR will show. The hour flashes. Press the + or
- button to choose the hour.
4. Press SET to confirm and move to the minutes. The MINUTES will show. Minutes flash. Press
the + or - button to choose the minutes.
5. Press SET to confirm and move to the year. The YEAR 2020 will show. Year will flash. Press
the + or - button to change the year.
6. Press SET to confirm and move to the month. The MONTH will show. The Month will flash.
Press the + or - button to change the month.
7. Press SET to confirm and move to the date. DATE will show. Date will flash. Press the + or -
button to change the date.
To Next Page
Loading...
Need help?
General
