La Crosse Technology WS-8248 User Manual

WS-8248
ATOMIC CLOCK WITH INDOOR TEMP/HUMIDITY AND OUTDOOR
TEMPERATURE
Instruction Manual
FEATURES:
ATOMIC CLOCK:
• WWVB Radio controlled time with manual time setting
• Time display: hour, minute, second
• Alarm setting with snooze function
• Complete calendar display
• Weekday display (3 languages to choose from: English, French and Spanish)
• Time zone setting
• Daylight savings time ON/OFF option (DST)
• Indoor temperature and humidity display
• Outdoor temperature display via 433MHz transmission
• Wall mount or freestanding
• Current moon phase display
OUTDOOR TEMPERATURE TRANSMITTER:
• Remote transmission of outdoor temperature to the atomic clock by 433 MHz signals
• Wall mounting case
TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE TRANSMITTER
The transmitter uses 2 x AA,1.5V batteries. To install and replace the batteries, please follow the
steps below:
1. Remove the cover.
2. Insert the batteries, observing the correct polarity (see marking inside battery compartment).
3. Replace the battery cover on the unit.
Alkaline batteries are recommended for use in both units. Avoid using rechargable batteries.
TO INSTALL AND REPLACE BATTERIES IN THE ATOMIC CLOCK
The atomic clock uses 3 x AA, 1.5V batteries. To install and replace the batteries, please follow the
steps below:
1. Pull down on the tab at the top of the battery cover and lift up to remove the cover.
2. Insert batteries observing the correct polarity (see marking inside battery compartment).
3. Replace compartment cover.
DO NOT SET THE CLOCK.
SETTING UP:
Mounting Bracket
LCD2
display
LCD1
display
Hanging holes
Function keys
Foldable stands
Battery cover

La Crosse Technology WS-8248 Specifications

General

Display Type	LCD
Snooze Function	Yes
Alarm	Yes
Time Display Format	12/24 Hour
Alarm Settings	Single Alarm
Power Source	AC Adapter
Temperature Display	Indoor temperature
Backup Battery Type	CR2032 (Included)

Summary

Battery Installation Guide

Temperature Transmitter Battery Installation

Instructions for installing and replacing batteries in the outdoor temperature transmitter.

Atomic Clock Battery Installation

Instructions for installing and replacing batteries in the atomic clock unit.

Clock Setting and Configuration

Initial Setup Procedures

Manual Settings Configuration

Time Zone Setting

Procedure to select the correct time zone for accurate time display.

DST Setting (Daylight Saving Time)

Radio-Controlled Time Setting

Language Setting

Manual Time Setting

Procedure for manually setting the hour, minute, year, month, and date.

Year, Month, and Date Setting

Setting the current year, month, and date for accurate calendar display.

Alarm and Snooze Settings

Signal Reception and Display Modes

Outdoor Temperature Transmitter Reception Check

WWVB Radio Controlled Time

Explanation of how the atomic clock receives and synchronizes time signals.

Positioning and Troubleshooting

Troubleshooting Common Issues

Solutions for problems like faint LCD, no signal, or incorrect readings.