6
Muting the Alarm
To mute the alarm, wait until the controller is showing the t1H high alarm screen and touch
the mute icon/button. The t1H high alarm screen will then ash to conrm you have muted
it and the alarm will stop sounding. Repeat for t2H alarm (if enabled).
Muting the alarm does not mean the alarm is cancelled and it will sound again after 15 minutes.
This is the default setting which you can change using the refrigerators menu. However, the
alarm will only cancel completely when the controller detects that the refrigerator is no longer
in an alarm state.
To change the interval between muting and the alarm sounding again please see section
Alarm Time Out page 8.
After 30 seconds the icons/buttons will disappear from the front of the controller and it will
display the temperature alternately with any active alarms. To activate the icons/buttons again,
put your hand across the controller and they will become active after 2 seconds of appearing.
ALTHOUGH THE REFRIGERATOR WILL REACH 5oC WITHIN ABOUT AN HOUR, YOU
SHOULD LEAVE THE FRIDGE RUNNING FOR 24 HOURS BEFORE FILLING WITH
TEMPERATURE SENSITIVE VACCINES AND PHARMACEUTICALS.
While your refrigerator is cooling down without contents, it is a good time to set up all the
functions you want to use on your fridge. Some functions you can only view, not change.
To enable/view functions, rst you need to wake the controller menu. This is done by placing
your hand for at least 2 seconds across the controller. This contact will make the icons/buttons
visible.
To access the menu, hold the two arrow icons/buttons on the right hand side of the controller
simultaneously for at least 2 seconds.
Accessing the Menu
°
°
t
1
C
H/L
P
Make the icons/buttons
visible by placing your hand across
the controller for at least 2 seconds
Access the menu by
holding the two arrow
icons/buttons for at least 2 seconds
To Next Page
Loading...
Need help?
General
