63
INSP/TESTS No. CONDITIONS AND REQUIREMENTS INST/LCC# RESULTS PASS
Hi-Pot
1 1000V for 1 minute. Hi Pot Tester
Final
1 Check for Leaks Visual
2 Unit must be Clean and Dry Visual
3 All parts in place in good condition Visual
4 Verify that thermostat on back of tank is installed properly. Visual
5 Make sure drain hose is routed over top of wash pump. Visual
6 Perform FACTORY RESET Visual
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
To Next Page
Loading...
