11
ENABLING USER PASSWORD USAGE (primary and service password)
•
Select “PASSWORD ON / OFF”
•
Press OK (F1).
•
Press the ON
button to enable the usage of user passwords and return to the menu PASSWORD MANAGEMENT.
To return to the work program view, press the EXIT button twice .
•
From this moment on, whenever the user wants to access the digital programmer ET‑DSEL to change the automatic door work
program, the primary or service password must be entered.
When the user decides to enable password usage, it is recommended to change the combination of both primary
and service password.
DISABLING USER PASSWORD USAGE
•
From the PASSWORD MANAGEMENT section, select “PASSWORD ON / OFF”
•
Press the button OK (F1)
•
Enter the primary password
•
Enter the primary password
•
Press the OFF button (F1) to disable user password usage.
To return to the general programming menu, press the EXIT button twice
Access to the digital programmer ET‑DSEL as program selector now is free.
4.2.3) LANGUAGE
To select the language perform the operations listed below:
1. Press the button
for 5 seconds to enter the general programming menu.
(see Diagram 1 in the previous paragraph)
2. Press the button F1 three times to go to the "Language" sub‑menu.
3. Press the Enter button
to access the “Language” section.
•
Use the buttons F2 and
to move the arrow in correspondence with the language
desired.
•
Press the EXIT button to return to general programming menu.
•
Press the EXIT button
again to return to the main view of the automatic door work
program.
To Next Page
Loading...
Need help?
General
