13
Install the plastic side panels (1), right and left, on the transom sides and fasten them by using two TCEI screws 5 x 20.
35
If the electric lock is required, place it in the centre of the transom in case of double leaf door, or on the right side of the
transom in case of single leaf door with leftward opening or to the left side of the transom in case of single leaf door
with rightward opening.
The electric lock lever shall hitch to the bracket provided on the carriage.
Comply with the fastening dimensions on fig.3-E, 4-E, 5-E and fasten the electric lock by using screws M6 x 10.
36
Roll the electric lock connecting cable up around the cable gland so that it cannot get entangled in the moving
devices, then connect it to the electric lock cabling by using two terminals and insert the connector of the electric lock
in the LOCK 1 connector of the electronic control unit.
40
35
36
37
39
40
37
38
39
38
To Next Page
Loading...
