3
Make Connections to your Receiver Unit
Install Batteries in the Remote Control
Insert the batteries supplied
(2x AAA alkaline) into the remote
taking care to observe the
polarity indicated in the battery
compartment.
Switch On
Switch on power.
Use your TV remote to Set your TV
to the input you have connected
your receiver to.
If your satellite dish is correctly
aligned for Free-to-Air channels,
after a few seconds a BBC TV
channel will be displayed
SAT-In
Connect
to Satellite
Downlead
HDMI-Out
Connect
to an HDMI
Socket on
your TV
DC-In
Connect to
the Power
Adaptor
technical@philex.com 3 www.phil ex.com
To Next Page
Loading...
