To Next PageTo Next PageTo Previous PageTo Previous Page
Need help?Do you have a question about the LaboGene Scanvac Basic and is the answer not in the manual?
General| Type | Freeze Dryer |
|---|---|
| Temperature of condenser | -55°C |
| Model | LaboGene Scanvac Basic |
| Capacity | 4L |
| Power Supply | 230V, 50/60 Hz |
Guarantees product testing, warranty validity, and liability limitations.
Explains warning and note symbols for user safety and attention.
Introduces the CoolSafe series as compact, easy-to-use freeze dryers for various applications.
Emphasizes reading the manual for safe and effective product use.
Details electrical protection and system safety design according to EN 61010-1.
Covers mains supply, air circulation, clearance, and location for the CoolSafe unit.
Details connecting a vacuum pump, recommended model, and required accessories.
Explains equipping the CoolSafe with necessary accessories for freeze-drying processes.
Locates the main On/Off switch and mains cable connector.
Lists indicators for the CoolSafe Basic control panel, including display and AWO indicator.
Describes the electronic control system for CoolSafe Pro, including keyboard and display interface.
Explains how the display shows process information and temperature readings.
Describes navigating the main menu to select operational modes like MANUAL, AUTOMATIC, etc.
Details selecting COOLING STOP and COOLING START options within the manual mode.
Explains how to exit menus with options to leave, save, or save and start changes.
Outlines inputting parameters for PREFREEZE, TIME, PRESSURE, and shelf intervals for automatic cycles.
Explains exiting the RELEASE, DE-ICE, and STOP menus.
Specifies using the transparent acrylic lid and selecting manifolds/chambers for operation.
Explains the balance in the freeze-drying process and factors affecting its efficiency.
Lists key factors influencing freeze-drying efficiency, such as sample surface area and condenser temperature.
Provides a visual overview of the CoolSafe unit with labeled components for reference.
Details pre-operation checks: condenser status, valve states, pump run time, and cooling readiness.
Describes the setup and initial steps for freeze-drying using manifolds.
Instructions for applying vacuum, checking indicator, and connecting flasks to manifolds.
Steps to stop the process, equalize pressure, and remove flasks from manifolds.
Steps for freeze-drying using chambers, including setup and material placement.
Methods for de-icing the freeze dryer, including room temperature or hot water methods.
Procedure for stopping the vacuum pump to prevent condensation and ensure longevity.
Lists error codes (E_1, E_2, E_3) and their meanings for troubleshooting.
Instructions for cleaning the condenser and greasing rubber parts of the CoolSafe unit.
Refers to the vacuum pump manual and general maintenance checks for oil and filters.
Provides a note on handling spills and cleaning the concentrator chamber.
Explains the theoretical basis of freeze-drying, phase changes, and energy transfer.
Details the sublimation (solid to vapor) and desorption (sorbed water removal) steps of the process.
Presents a table of water vapor pressure data versus temperature for reference.
Refers to an external catalogue for detailed technical specifications and available accessories.
