INSTRUCTION MANUAL-CoolSafe Freeze Dryersmodels
Page
4
/
19
1. Introduction
The CoolSafe series of Freeze Dryers are small, compact and easy to use Freeze Dryer.
Using the wide range of accessories including a selection of chambers and manifolds, the CoolSafe’s can be
employed for a large variety of different applications.
Freeze-drying is often used for sample preparations and for preservation and storage of biological and
pharmaceuticals materials. Freeze-drying is also ideally suitable for substances that are heat sensitive.
If you are not familiar with the freeze-drying process, please read Section 7, which outlines the freeze-drying
process.
2. Safety precautions
2.1. General information
Please read this entire manual to fully understand the safe and effective use of this product.
Should you have any comments about this manual we will be pleased to receive them.
2.2. Safety
In case of overload, an automatic safety device stops the freeze dryer.
All CoolSafe models are electrically protected with an over current circuit beaker.
The safety system is designed according to Safety requirements for electric equipment, control and
laboratory use (EN 61010-1), which assumes that two separate faults do not occur simultaneously.
NOTE LaboGene ApS. recommends using safety glasses for personal
protection when connecting flasks or other equipment to the freeze-dryer –
due to the risk of implosion.
3. Installation
3.1. Installation of the CoolSafe
Make sure that the mains supply is according to the specifications on the type label at the rear panel.
It is important that free air circulation is available at the air inlet and outlet grills. If the CoolSafe is
To Next Page
Loading...