laerdal SimPad PLUS - Sounds; Auxillary Button

46 47
Português
SimPad PLUS / Link Box PLUS - Informações regulamentares
US
Federal Communications
Commission (FCC) Statement
This device complies with part 15 of the
FCC rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference.
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there
is no guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
SimPad PLUS
FCC ID: QHQ-20430150
Link Box PLUS
FCC ID: QHQ-20430250
Cautions
• This transmitter must not be co-located
or operating in conjunction with any other
antenna or transmitter.
• Any changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s authority
to operate this equipment.
The use of shielded I/O cables is required
when connecting this equipment to any
and all optional peripheral or host devices.
Failure to do so may violate FCC rules.
For Portable Device Usage
(<20cm from body/Specific Absorption
Rate (SAR) needed))
Radiation Exposure Statement:
This device meets the government’s
requirements for exposure to radio waves.
This device is designed and manufactured
not to exceed the emission limits for
exposure to radio frequency (RF) energy set
by the FCC of the U.S. Government.
The exposure standard for wireless device
employs a unit of measurement known
as the Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6W/kg.
Tests for SAR are conducted using standard
operating positions accepted by the FCC
with the device transmitting at its highest
certified power level in all tested frequency
bands.