Lagoon 380 - Davit (Optional); Environment

LAGOON 380
1
NAVIGATION
19
• WINDLASS ANCHORING
- Release the gypsy brake.
- Activate the windlass with the control located in the saloon.
• HEAVING UP THE ANCHOR
- Lock the cable lifter snubber.
- Ensure the chain is properly set on the cable lifter.
- Slowly go near the anchor, using your engine (Don't use your win-
dlass to winch the boat).
- Release the bridle from the chain.
- Heave the anchor completely.
- Visually check the last meters till the anchor gets into contact with
the davit.
- Secure the anchor or anchor chain to the cleat.
- Release the anchor clutch.
In the case of electrical failure use the winch handle on the windlass
to lift anchor.
• MAINTENANCE
After each trip rinse the windlass and mooring line with fresh water.
Refer to the manufacturer's instructions for windlass maintenance
at the beginning or end of the season.
WARNING
Nobody should be aboard the tender during maneuvers car-
ried out with the davits.
WARNING
Windlass operations are dangerous:
- Always keep the anchor line unfouled and free.
- Always proceed with care, using gloves and always wea-
ring shoes.
NAVIGATION