LAGOON 380
7
PLUMBING
61
•FILLING
In order to prevent any handling mistakes, never fill the water and
fuel tanks at the same time.
During filling, avoid handling contaminants near the fillers.
Open and close the filler caps with the suitable key.
Check the filler cap seals for condition during filling.
The tanks are fitted with overflow outlets and vents.
Never insert the water filling hose deep down into the system in
order to prevent any over-pressure in the systems.
• MAINTENANCE
Inspection ports are provided on tanks and make possible the
cleaning of the inside.
NOTE: It may happen that the capacity of the fresh water tank or
tanks indicated on the page "Specifications" cannot be completely
used depending on the trim and load of the boat.
The water pump is switched on at the electrical panel.
The 3 way valve enables the water system source to be switched
from the starboard tank to the port tank (optional).
For optimisation of use of fresh water completely use up one tank's
supply before switching over to the other..
• SHORE POWER SOCKET FRESH WATER (OPTIONAL)
The vessel may be equipped with a connector for the shore supply
off reshwater.
The nozzle on the port transom extension enables a hose to be
connected to supply the onboard system from a quayside
freshwater hydrant.
Water tanks
RECOMMENDATION
- Pay attention to the quality of the water for the filling up.
Check if it is drinking water.
- It is possible to sterilize the tanks with a Clonazione tablet
(sold at the Chemist's).
- If the boat is not used for long, purify the tanks and pipes
with acetic acid (or white vinegar).
Fresh water system
RECOMMENDATION
- Never operate the water system equipment when the valve
is closed or the tank is empty (the electrical equipment
may be damaged).
- Check the water filter for condition (refer to manufacturer's
instructions).
WARNING
- Turn off shore water before leaving the vessel.
PLUMBING
To Next Page
Loading...
