How to improve dust collection on my laguna TS?
For poor dust collection in your Laguna Saw, check the capacity of the dust collection system, ensuring it has a minimum of 1000 cubic feet per minute at the machine. Also, check that the dust hose is not blocked and that the dust collector is not full.
What to do if my laguna TS will not start?
If your Laguna Saw won't start, there are several things to check: * Ensure the start switch is fully depressed. * Verify the electrical power cord is plugged into the outlet. * Confirm the electrical supply is on (reset the breaker if necessary). * With the power disconnected, inspect the wiring in the plug and to the machine, ensuring correct wiring, sufficient rubber insulation, and tight screws. * Make sure you are using the correct power (220V, not 110V). * Check that the ground wire is correctly wired.
Why is the cut quality poor on my laguna TS?
If you're experiencing a poor cut with your Laguna Saw, it could be due to several reasons. The blade might be dull or have a bent tooth, in which case you should change the blade. Also, ensure you are using the correct type of blade for the job. If your saw has scoring, make sure it's adjusted correctly.
Why does the blade slow down during a cut on my laguna TS Saw?
If the blade on your Laguna Saw slows down during a cut, several factors could be responsible: * A loose drive belt: Re-tension the belt. * A dull blade: Replace or re-sharpen the blade. * Feeding the wood too fast: Slow down the feed rate. * Insufficient set on the teeth: Change to a blade with the correct set. * Oil or dirt on the drive belt: Clean or replace the drive belts. * Fence not aligned correctly: Align the fence.
What causes the motor to overheat on my laguna TS?
If the motor of your Laguna Saw overheats, try the following: * Wait for the motor to cool down before restarting. * If the motor keeps shutting down, investigate the reason. * A dull blade can cause overheating, so change the blade. Other potential causes include overfeeding the wood, a clogged or faulty motor cooling fan, clogged motor cooling fins, or excessive ambient temperature.
What to do if my Laguna Saw will not stop?
If your Laguna Saw won't stop, it could be due to a faulty stop switch or a faulty internal contactor. Replace the stop switch or replace the contactor to resolve this issue.
Why does the blade on my laguna TS Saw overheat?
If the blade on your Laguna Saw overheats, it could be due to a dull blade (change or re-sharpen it), a pitch that is too small for the depth of cut (change to a blade with the correct pitch), or wood that is too hard for the selected blade (change the blade).
What to do if laguna TS motor tries to start but will not turn?
If the motor of your Laguna Saw tries to start but won't turn, wood jamming the blade could be the reason. Disconnect the power and try to turn the blade by hand to check for jamming. Also, consider replacing the capacitor or the motor.
Why is my Laguna Saw vibrating?
If your Laguna Saw vibrates, it might not be level on the floor. Re-level the machine, ensuring it has no movement. Another cause could be a damaged drive belt; in that case, replace both belts.
What causes a squeaking noise in my laguna TS Saw?
If you hear a squeaking noise from your Laguna Saw, check that the motor cooling fan is not contacting the fan cover. Also, inspect the bearings and the drive belt.
To Next Page
General
