To Next Page
T
Theresa BoyleAug 25, 2025
Why won't my laguna Fusion F3 start or keeps tripping the breaker?
- SScott WoodsAug 25, 2025
Your Laguna Saw might not be starting, or it may be tripping the breaker due to several reasons. It could be a faulty start capacitor (test and replace if needed), incorrect motor wiring connections (correct the connections), or a wiring issue (check and fix broken, disconnected, or corroded wires). The motor start/stop switch could be defective (replace the switch), or the motor itself might be at fault (test, repair, or replace). Other potential causes include a faulty run capacitor (test and replace), a tripped or faulty wall circuit breaker (ensure correct circuit size or replace the breaker), a power supply issue (ensure it's on and has the correct voltage), or a problem with the plug/receptacle (test wires and contacts; correct the wiring).
General
