Operator's Manual – Stacker Wall Street
©
LAI GAMES
MACHINE INSTALLATION and INSPECTION
When installing and inspecting “Stacker Wall Street”, be very careful of the
following points and pay attention to ensure that the players can enjoy the game
safely.
Be sure to turn the power OFF before working on the machine.
Make sure the power cord is not exposed on the surface (floor, ground, etc.) where
people walk.
Check that the rubber glide feet levelers are set correctly on the floor so that the
game cabinet is level and stable.
Always make complete connections for the integrated circuit (IC) logic PC Boards
and other connectors. Insufficient insertion can damage the electrical
components.
Only qualified personnel should inspect or test the integrated circuit (IC) logic PC
Boards.
If any integrated circuit (IC) logic PC Boards should need servicing. Please
contact the nearest LAI Games
Distributor. (Refer to the back page of this manual)
* CAUTION! *
Before Switching the machine on be sure to check that it has been set on the
correct voltage for your area!
Refer To the mains voltage adjustment section of this manual. Machines are
normally shipped on 220V AC unless otherwise specified.
* WARNING! *
Always Turn OFF mains power before removing safety covers and refit all safety
covers when work is completed.
To Next Page
Loading...
Need help?
General
