COMPUTER START UP DESCRIPTION
ACTIVATION THE USER MAY PRESS ANY FUNCTION BUTTON OR START PEDALING TO ACTIVATE DISPLAY.
NOTE: BIKE MUST HAVE THE AC ADAPTER PLUGGED INTO A WALL OUTLET IN ORDER TO
OPERATE PROPERLY.
INTRO SCREENS 1) DISPLAY WILL SHOW “U1”. THIS IS A USER IDENTIFICATION CODE. THERE ARE (4) AVAILABLE
USER ID PROMPTS (U1-U4). USE THE “UP” OR “DOWN” BUTTONS TO SELECT 1 OF THE 4
OPTIONS. ONCE A SELECTION IS MADE PRESS THE “ENTER” BUTTON.
2) USER WILL BE PROMPTED TO SELECT FROM 1 OF 4 TRAINING MODES (MANUAL, PROGRAM,
USER, OR TARGET HEART RATE). THE SELECTIONS WILL APPEAR (FLASH) IN THE UPPER
AREA OF THE TOP DISPLAY WINDOW. USE THE “UP” OR “DOWN” BUTTON TO SELECT ONE OF
TRAINING OPTIONS OR PRESS THE “START / STOP” BUTTON TO IMMEDIATELY START
TRAINING IN THE “MANUAL” MODE.
PRESETS
ONCE A USER IS IN A TRAINING MODE, THEY WILL HAVE THE OPTION TO PRESET
INDIVIDUAL DISPLAY FUNCTIONS (TIME, DISTANCE, CALORIE, PULSE). AFTER PRESETS ARE
ENTERED, PRESS THE “START / STOP” BUTTON TO START TRAINING. IF NO VALUES ARE
PRESET, THE COMPUTER FUNCTIONS WILL COUNT UP FROM “0”.
RESISTANCE BIKE IS EQUIPPED WITH AN ADJUSTABLE RESISTANCE MECHANISM. THIS FEATURE WILL
ALLOW A USER TO CHOOSE FROM 1-8 LEVELS OF VARIED RESISTANCE. A USER CAN ADJUST
RESISTANCE AT ANY TIME DURING A TRAINING MODE BY PUSHING THE “UP” or “DOWN”
BUTTON (EXCEPT IN TARGET HEART RATE MODE).
BUTTON FUNCTIONS
ENTER SELECTS & SETS DISPLAY FUNCTIONS.
START / STOP ACTIVATES & STOPS COMPUTER FUNCTIONS.
UP SELECTS PROGRAM MODE & ADJUST (INCREASES) DISPLAY SETTINGS.
DOWN SELECTS PROGRAM MODE & ADJUST (DECREASES) DISPLAY SETTINGS.
RESET 1) USED TO ZERO OUT AN INDIVIDUAL DISPLAY FUNCTION OR RESET ALL THE FUNCTION
VALUES SIMULTANEOUSLY BY HOLDING DOWN THE BUTTON FOR 4 -SECONDS.
2) PRESET USER PROGRAMS: RESET TO THE INITIAL PRE-PROGRAMMED SETTINGS.
RECOVERY THE RECOVERY BUTTON ALLOWS USERS TO EVALUATE THEIR FITNESS LEVEL AFTER
COMPLETING A TRAINING SESSION.
DISPLAY FUNCTIONS
TIME COMPUTER DISPLAY WILL ACCUMULATE TOTAL TRAINING TIME IN 00:00 (MINUTES :
SECONDS). COMPUTER WILL COUNT UP OR DOWN A MAXIMUM OF 99:59.
PRESET TARGET TRAINING TIME: USE THE “ENTER” BUTTON TO SCROLL TO THE TIME
FUNCTION AND USE THE “UP” & “DOWN” BUTTONS TO ADJUST THE SETTING. SETTINGS WILL
BE ENTERED IN 1:00 MINUTE INCREMENTS AND THE COMPUTER WILL COUNT DOWN FROM
THE SET TIME. ONCE THE DESIRED TIME IS SET, PRESS “START / STOP” TO BEGIN TRAINING.
ONCE A SET TRAINING TIME IS COMPLETED, THE COMPUTER WILL “BEEP” FOR
APPROXIMATELY 8 SECONDS AND COMPUTER WILL RESET TO THE INITIAL SETTING.
COMPUTER OPERATION PAGE 12
COMPUTER INSTRUCTION
To Next Page
Loading...