Lamax Electronics S7 Dual - Page 7

7
connected to the camera, the date and time are automatically synchronized. Press the
OK button to get to the settings and use the arrow keys to set each part (year, month,
day, hours, minutes and seconds). You must conrm each setting by pressing OK. Once
everything is set, press OK again to conrm the changes.
c) Key Sound – enables or disables key tones. Press the OK button to get to the settings,
use the arrows to select yes or no and press OK again to conrm.
d) Auto Shutdown – allows you to set the time after which the device automatically shuts
down when idle after 1 or 5 minutes. Press the OK button to get to the settings, use
the arrows to select the time period, or to turn o the function and press OK again to
conrm.
e) Volume – adjusts the volume of the camera output (video playback and voice instruc
-
tions). Press OK to get to the settings and use the arrow keys to select the level 0-10 and
conrm with the OK button.
f) Power Save Mode – sets the display to automatically turn o when idle after 1 or 3
minutes or the function may be turned o completely. Screen timeout also works when
the camera is recording. Press the OK button to get to the settings, use the arrow keys to
select the desired option and then press OK again to conrm.
g) Grid Frequency – allows you to select the frequency in accordance with the grid fre
-
quency (on the European continent the frequency is 50 Hz and the Americas and parts
of Asia it is 60 Hz).
h) G-Sensor – the G-sensor enables the camera to record impacts, for example, in a traf
-
c accident. Once the camera detects the impact, the current recording is immediately
locked so that it cannot be overwritten. The sensor can be set to several dierent sen
-
sitivities (high, low, medium) or switched o completely. Press the OK button to get to
the settings, use the arrow keys to select the desired option and then press OK again
to conrm.
i) Parking Mode – parking mode functions even when the camera is not being powered,
thanks to the integrated battery. The camera automatically turns on and starts recording
when the g-sensor detects an impact. If there is no further impact detected, after about
20-30 seconds the recording is saved, locked and the camera turns o again. When park
-
ing mode is active, the camera turns o the display to prevent it being noticed.
Parking Mode settings allow you to adjust the sensitivity of the G-Sensor: Low, Medium,
High or completely o. Select the settings as needed depending on the circumstances.
In order for Parking Mode to function it is necessary to fully charge the battery. If the
battery is not charged, the camera will not have the power necessary to begin recording.
j) Motion Detection – when motion detection is on, the camera automatically starts re
-
cording when it detects movement in the front camera eld of view. The camera records
for about 20 seconds, locks the recording and stops recording if not further movement
is detected. Press the OK button to get to the settings, use the arrow keys to select on or
o and press OK again to conrm. The motion detection function only works when the
camera is turned on. For prolonged use, the camera must be permanently connected to
the power supply.
k) GPS Status – as soon as the module connects to the camera and picks up a signal, the
GPS icon turns green and the current coordinates appear on the display. In the settings,
HR SLO LT HU PL SK CZ DE EN HR SLO LT HU PL SK CZ DE EN