How to disable-enable the SOFT-START (0300834)
By default the machine is provided with SOFT START system with gradual start of the wash pump.
It’s possible to disable this function by following the instructions below.
1. Turn on the machine by wall switch and press switch ‘A’ that you can find on the control panel. At
this moment the thermometers’ displays light up and the tank fills up. When the tank is full, the cycle
lamp lights up,
2. Open the door of the machine,
3. Turn the machine off by pressing pushbutton ‘A’,
4. Press the pushbutton of the Drain Pump ‘F’,
5. Always keeping pressed the Drain Pump pushbutton ‘F’, turn the machine on by pressing switch ‘A’,
6. Keep the pushbutton ‘F’ pressed for 7 seconds,
7. Release the pushbutton and turn the machine off by pressing switch ‘A’.
To enable again the SOFT-START function, follow the same steps.
How to disable-enable the AUTOMATIC START
By default the machine is provided with MANUAL start by cycle pushbutton ‘C’.
It’s possible to set (enable) the AUTOMATIC start of the cycle at the door closing by following the
instructions below:
1. Turn on the machine by wall switch and press switch ‘A’ that you can find on the control panel. At
this moment the thermometers’ displays light up and the tank fills up. When the tank is full, the cycle
lamp lights up,
2. Open the door of the machine,
3. Turn the machine off by pressing pushbutton ‘A’,
4. Press the Wash time selection pushbutton ‘B’,
5. Always keeping pressed the pushbutton ‘B’, turn the machine on by pressing switch ‘A’,
6. Keep the pushbutton ‘B’ pressed for 7 seconds,
7. Release the pushbutton and turn the machine off by pressing switch ‘A’.
To enable again the MANUAL start function, follow the same steps.
To Next Page
Loading...
Need help?
General
