lamber F92-dy - Page 56

Partial cycles
(number of partial
performed cycles)
n°…… (not editable)
To confirm
(Only be reset with Reset FunctionPartial Cycles)
Total
C
ycles
(Number of Cycles
performed)
n°…… (not editable)
To confirm
Partial Cycles Reset
n°…… yes/no
To confirm
("yes" to reset value)
A
utomatic Starting YES To confirm
NO
Time phase 2 Time
To confirm
Filling of the tan
k
(10÷360")
BREAK TANK YES
To confirm Attention: this parameter
NO is available only on models
LP6/8-dy e LP31/38-dy
Second washing YES To confirm Attention: this parameter
NO is available only on models
LP6/8-dy e LP31/38-dy
Rinsing 2 YES To confirm
NO
Discharge YES
To confirm
(Drain pumpe) NO
Drain time (0÷60")
To confirm Attention: this parameter is
end cycle not shown if the dishwashers is
not equipped with drain pump
Drain Time at the (0÷360") To confirm Attention: this parameter is
end of the da
y
not shown if the dishwashers is
not equipped with drain pump
Water change (0÷50) Interval for wate
r
To confirm
change cycles
Water dump and fill (0÷50) Intervallo cicli
To confirm
cambio acqua