- DO NOT attempt to move, install, set-up or operate this machine until you have read and fully
understood this Manual. If doubt persists, ask your supervisor;
- never leave tools, parts or other loose material on or in the machine;
- Before switching the equipment the equipment on, make sure that the model plate data conforms to
that of the electrical and water distribution network;
- remember that even with the mains isolator in the “OFF” position, the incoming cables are still live;
- BEFORE starting machine o cycle, after any maintenance or repair work, make sure all protective are
correctly installed;
- be vigilant at all times, remember that your safety and that of your fellow workers depend on you;
- when moving or lifting the machine, care must be taken to comply with all the relevant regulations
governing such operations;
- installation should be carried out by qualified personnel according to the manufacturer's instructions.
- this equipment should be destined to the use which it has been conceived for. Any other application
should be considered improper and consequently dangerous;
- the equipment should only be used by personnel trained for its use;
- Repeat regularly the training courses to avoid injury.
- Do not open the door when the machine is working. There is a risk of splashing boiling water
impregnated with detergent;
- When the door is open and the machine is on, do not immerse your bare hands in the washing tank;
- The machine must not be installed in areas at risk of explosion, freezing or not constructed in
accordance with local health and safety norms.
- Touch the control screen only with your fingers, avoiding the use of sharp objects.
- At the end of the working day turn off the water tap and turn the master switch off.
1.3 SPECIAL SAFETY REGULATIONS
- adjustment and repairs must be carried out only by personnel qualified. Repair carried out by unskilled
personnel may be dangerous;
- perfect washing-up results as far as hygiene concerns and a correct operation of the washing
machine can be assured only in case the instructions reported in the present handbook are carefully
followed;
- the machine must be only used by authorized personnel which must comply with sanitary measures;
- do not leave the machine in environment with temperatures inferior to 0°C;
- the machine protection degree is IP55 for Control board and IP21 for machine, therefore it should
not be washed with direct high pressure jets of water;
- If the power cable is defective, it must be replaced by your manufacturer or by a technical
assistance service or by a qualified technician in order to avoid risks.
1.4 USE OF CHEMICAL PRODUCTS (detergents, sparkling aid)
CAUTION: Observe the safety notes and dosage data for the use of chemicals. During the use of the chemical
substance wear protective clothing, gloves and protective glasses. Do not mix different cleaning products.
- Observe the safety notes indicated and the dosage recommendations for the use of chemicals.
- When using chemicals, wear protective clothing, gloves and goggles.
- Use only suitable products for industrial dishwashers directly recommended by Lamber.
- Do not mix cleaning products to avoid crystallization that could ruin the detergent dispenser.
- Do not use products that create foam as hand soap or detergent for manual washing.
These products should not be introduced into the machine not even by pre-treatment of dishes.
To Next Page
Loading...
Need help?
General
