64
10 - PARAMETERS’ PROGRAMMING
10.1 – Modification of parameters’ programming
1
1
7
234567
A
B
C1
C2
D
E
F
G
H
L
M
N
V
O
P
Q
R
1. Make sure that the wall switch is on;
Apply voltage to the machine pressing the main switch located on the control panel: it will turn on the
display of the thermometers C1, C2 and the “V” information display which will show the sign “OFF”;
Push on the “H-G-D” buttons at the same time : on the display “PARAMETERS” will appear ;
2. Push “G”(start) in order to see all the parameters in sequence (see complete list on the following
page); (with the “H”(stop) button it is possible to go back to the previous parameter )
3. Modify the parameter acting on the “E” button to reduce and on the “D” button to increase the value of
this parameter;
4. To validate the value of the modified parameters it is necessary to push the button “G”(start) until the
last “OFF” appears;
5. Push the “A” line button (on the information display you’ll see that “ON” will appear);
6. Start the machine and check the right value of the established parameters.
To Next Page
Loading...
Need help?
General
