IMPORTANT SAFETY INFORMATION
Your safety is of the utmost importance. Please make
sure that you read this instruction booklet before
attempting to install or use the appliance.
IMPORTANT: Any installation work must be
carried out by a qualified electrician or
competent person.
o The extractor must be installed in accordance with the
installation instructions and all measurements followed.
o If the cooker hood is installed for use above a gas appliance then
the provision for ventilation must be in accordance with the Gas
Safety Codes of Practice BS.6172, BS.5440 & BS.6891 (Natural
Gas) and BS.5482 (LP Gas) 1994, the Gas Safety (Installation &
Use) Regulations, the Building Regulations issued by the
Department of the Environment, the Building Standards
(Scotland) (Consolidated) Regulations issued by the Scottish
Development Department.
o It is dangerous to alter the specifications or to modify this
product. Do not tamper with it or attempt to modify the
appliance in any way.
o When installing the hood, ensure that the following distances are
observed between the worktop and the bottom of the cooker
hood:
Recommended: 750 mm
Minimum: 700 mm
IMPORTANT: DO NOT SET YOUR EXTRACTOR
LESS THAN 700mm ABOVE YOUR WORKTOP.
o When installed between adjoining wall cabinets, the cabinets
must not overhang the hob.
o The edges of the extractor are sharp – be mindful of this as you
handle your appliance, especially during installation and
cleaning. DO NOT CLEAN IN BEHIND THE GREASE FILTERS!
To Next Page
Loading...
