How to troubleshoot no welding power in Lampert Welding System?
If your Lampert Welding System has no welding power, check the power connection and main voltage. Also, inspect the welding cable connections. Ensure proper grounding by connecting contact clamps directly to the workpiece. If the issue stems from a power error, press the reset button or cycle the device's power. If the problem persists, it is recommended to have the device serviced.
Why does the power fuse keep blowing on my Lampert Welding System?
If the power fuse or automatic safety is blowing, it could be due to insufficient power protection. Install proper power protection. If the mains fuse releases during no-load operation, send the device to be serviced.
What to do if my Lampert Welding System is hard to ignite?
If your Lampert Welding System is hard to ignite, ensure you have a good grounding contact by connecting it to the workpiece. Also, the electrode may be dirty or burned down. In this case, re-sharpen the electrode.
Why is the welding unsatisfactory with my Lampert PUK 3 professional plus?
Unsatisfactory welding may be due to the wrong safety gas or a lack of inert gas. Use inert gas (Argon 4.6).
What causes heavy oxidation on the welding spot with a Lampert PUK 3 professional plus Welding System?
Heavy oxidation development on the welding spot may be caused by using the wrong safety gas or not using inert gas. Use inert gas (Argon 4.6).
How to fix oxidation and soot development with Lampert PUK 3 professional plus?
Oxidation and soot development can occur if the gas pressure is too high. Reduce the flow to approximately 3 to 4 l/min.
Why does the tungsten electrode melt off on my Lampert Welding System?
If the tungsten electrode melts off, it could be because the tip is sharpened too much. Sharpen it to the recommended angle (approximately 15°).
How to prevent tungsten in basic material when using Lampert PUK 3 professional plus?
To prevent tungsten from getting into the basic material, avoid applying too much electrode pressure on the workpiece. Lightly touch the workpiece, ensuring it barely ignites enough.
What causes the tungsten electrode to stick to the work piece with Lampert PUK 3 professional plus?
If the tungsten electrode adheres to the workpiece, it could be due to excessive electrode pressure. Lightly touch the workpiece so that it barely ignites enough.
Why does the work piece stick to the welding table when using Lampert Welding System?
If the workpiece adheres to the welding table, it may be due to a bad connection. Use clamps or pliers to improve the connection.
General safety guidelines for operating the device.
Personal safety measures and potential dangers during operation.
How to adjust output and welding time for desired results.
Step-by-step guide for performing welding operations.
General| Dimensions | 165 x 145 x 240 mm |
|---|---|
| Weight | 4.8 kg |
| Gas Pre-flow Time | 0 - 10 s |
| Gas Post-flow Time | 0.1 - 25 s |
| Power Supply | 230 V / 50 Hz |
To Next Page
