To Next PageTo Next PageWhat causes a bent driveline on my Land Pride Rotary Cutters RCR1860 Lawn Mower?
If you have a bent driveline on your Land Pride Lawn Mower, it could be contacting the frame. Reduce the lift height in the transport position. It might also be contacting the drawbar, so reposition the drawbar. Also, bottoming out can bend the driveline, so shorten the driveline. Finally, binding up due to not lubricating enough can cause it, too.
What causes excessive side skid wear on my Land Pride Lawn Mower?
If you're seeing excessive side skid wear on your Land Pride Lawn Mower, it might be because the cutting height isn't level, the soil is abrasive, or you're cutting too low. Adjust the cutter height to address these issues.
Why is the oil seal leaking on my Land Pride Lawn Mower?
If you notice an oil seal leaking on your Land Pride Lawn Mower, it could be due to several reasons. The gearbox might be overfilled, so drain it to the side plug hole. The seals could also be damaged, requiring replacement. Additionally, grass or wire wrapped on the shaft in the seal area can cause leaks, so check the seal areas daily.
What causes tailwheel support failing on Land Pride Lawn Mower?
If you're experiencing tailwheel support failing on your Land Pride Lawn Mower, it could be due to lowering it too fast. Adjust the rate of drop. Hitting objects when turning can also cause this, so reduce speed on turns.
General| Cutting Width | 60 inches |
|---|---|
| Hitch Type | Category 1 |
| Gearbox HP Rating | 40 hp |
| PTO Speed | 540 RPM |
| Horsepower Requirements | 20-40 hp |
| Gearbox Rating | 40 HP |
| Blade Carrier | Round Pan |
| Driveline Protection | Shear Bolt |
| Number of Blades | 2 |
| Required PTO HP | 20 HP |
| Cutting Height Range | 1.5 - 9 inches |
Thoroughly read and understand instructions before operation and ensure operator is trained.
Alerts to potential hazards and requires extra safety precautions. Indicates serious injury risk.
Wear appropriate clothing, hearing protection, and avoid distractions.
Relieve pressure before disconnecting hydraulic lines to prevent serious injury.
Operate tractors with ROPS and seat belts; fasten snugly for safety.
Warning about contact with drivelines causing injury or death. Keep away.
Warning to prevent injury from thrown objects by ensuring guards are installed.
Warning to keep away from rotating blades to prevent serious injury or death.
Warning regarding driveline contact causing death. Keep away and ensure guards are in place.
Warning not to operate if guards are missing.
Multiple safety warnings including hazards from PTO, driveline, and thrown objects.
Warning to operate only with 540 RPM PTO to avoid injury or machine damage.
Warning not to operate if guards are missing due to entanglement hazard.
Specifies tractor PTO, hitch type, and horsepower requirements for the rotary cutter.
Step-by-step guide for safely attaching the rotary cutter to the tractor's 3-point hitch.
Detailed instructions for installing the driveline, including slip-clutch and shear-bolt types.
Procedure to check driveline collapsed length to prevent structural damage.
Crucial safety warnings and precautions related to operating the cutter.
Detailed pre-operation checks on the tractor, cutter, and driveline.
Procedures to prevent blade lock-up during PTO engagement and disengagement.
Detailed instructions for inspecting, sharpening, and replacing cutter blades.
