EasyManua.ls Logo

Land Pride ZT60i - User Manual

Land Pride ZT60i
64 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Table of Contents
Cover photo may show optional equipment
not supplied with standard unit.
Read the Operator’s Manual entirely. When you
see this symbol, the subsequent instructions and
warnings are serious - follow without exception.
Your life and the lives of others depend on it!
!
© Copyright 2014 Printed
ZT60i & ZT72i (S/N 748110+) Accu-Z
®
Zero Turn Mowers
357-552M
Operator’s Manual
2/06/14
33758

Table of Contents

Other manuals for Land Pride ZT60i

Preview: Parts Manual
Parts Manual54 pages

Questions and Answers

  • A
    Andrew PhillipsAug 1, 2025
    Why won't the starting motor crank the engine on my Land Pride ZT60i?
    • D
      Daniel LloydAug 1, 2025
      The starting motor might not crank the engine of your Land Pride Lawn Mower due to several reasons. Ensure the control levers are in the neutral position and fully out, and that the park brake is engaged. Also, check that the blade engagement switch is disengaged. A weak or dead battery could also be the cause, so recharge or replace it. Finally, inspect for loose or broken switches and damaged electrical wiring, repairing or replacing them as needed.
  • A
    Ashley SmallAug 8, 2025
    What to do if my Land Pride ZT60i Lawn Mower loses power or won't operate in either direction?
    • C
      Christina JonesAug 8, 2025
      If your Land Pride Lawn Mower experiences a loss of power or won't operate in either direction, start by checking if the bypass valve is open and close it. Reduce the load on the mower if it's excessively loaded. Inspect for loose or lost steering hardware and replace it if necessary. Additionally, examine the ground drive belt and pump idler pulley for damage, replacing them and tightening the idler pulley if loose. Also, check the oil level in the transaxle and fill to the correct level. Service the air cleaner if there are restrictions.
  • R
    Richard MilesAug 15, 2025
    How to fix ragged or uneven grass cutting with my Land Pride ZT60i?
    • J
      jacob13Aug 15, 2025
      Ragged or uneven grass cutting with your Land Pride Lawn Mower can be caused by several factors. Dull, bent, or broken cutting blades can be sharpened or replaced. Clean the underside of the deck if it's full of wet, sticky grass. Ensure the cutting blades are operating at full engine speed (3600 rpm). Check if the belt over center take-up is loose and tension it. Also, make sure the deck is level and check the air pressure in all 4 tires.
  • K
    kbrooksAug 25, 2025
    What to do if my Land Pride ZT60i Lawn Mower engine cranks but doesn't start?
    • T
      Tanya BaxterAug 25, 2025
      If your Land Pride Lawn Mower's engine cranks but doesn't start, the possible cause is that there is no fuel in the fuel tanks, so fill the tank. Alternatively, the fuel filter or fuel line might be plugged, in which case you should replace the fuel filter or fuel line.

Summary

Important Safety Information

Safety at All Times

General safety practices and precautions for operating the mower.

Practice Safe Maintenance

Guidelines for performing safe maintenance on the mower.

Keep Riders Off Mowers

Safety warning against allowing unauthorized riders on the mower.

Use Seat Belt and ROPS

Importance of using the seat belt and ROPS for operator safety.

Avoid High Pressure Fluids Hazard

Warnings and precautions regarding hydraulic fluid hazards.

Prepare for Emergencies

Recommendations for emergency preparedness, including first aid and fire safety.

Tire Safety

Safety precautions for changing and inflating tires.

Wear Protective Equipment

Guidelines on wearing appropriate personal protective equipment.

Section 1: Assembly & Set-up

Folding ROPS Installation

Instructions for installing the Roll Over Protection System (ROPS).

Section 2: Operating Procedures

Operating Checklist

A checklist of pre-operation tasks to ensure safe and proper functioning.

Control Panel

Explanation of the mower's control panel layout and functions.

Park Brake

Explanation and operation of the park brake lever.

Control Levers

How to use the control levers for steering and speed.

Moving Mower with Stalled Engine

Instructions for moving the mower if the engine is inoperable.

Engine Starting

Detailed steps for safely starting the mower's engine.

Engine Shut-Down Sequence

Correct procedure for shutting down the mower's engine.

Safety Start Interlock System

Explanation and testing of the mower's safety interlock features.

Driving the Mower

Guidelines and warnings for operating the mower safely.

To Start and Increase Speed

How to start moving and adjust speed using control levers.

To Decrease Speed and Stop

Procedures for slowing down and stopping the mower.

To Steer

Safe Operating Instructions

Comprehensive safety rules for operating the mower.

Good Operating Practices

Section 3: Adjustments

Park Brake Adjustment

Lower Control Lever

Upper Control Lever

Ground Drive Belt Tensioning

Deck Drive Belt Tensioning

Deck Cutting Height and Leveling

Section 5: Maintenance & Lubrication

Maintenance

Maintenance Safety

Critical safety precautions to follow during maintenance.

Maintenance Schedule

A schedule of recommended maintenance tasks based on operating hours.

Deck Drive Belt Removal & Installation

Ground Drive Belt Removal & Installation

Hydrostatic Drive System

Information and warnings related to the hydrostatic drive system.

Transaxle Oil Check & Filling

Transaxle Oil & Filter Change

Transaxle Purging Procedures

Fuel System

General Engine Maintenance

Engine Oil & Oil Filter

Procedures for checking and changing engine oil and filter.

Change Engine Oil

Detailed steps for changing the engine oil and filter.

Engine Air Filter

Instructions for inspecting, cleaning, and replacing the engine air filter.

Engine Air Filter Handling

Blade Inspection

Checking mower blades for wear and damage.

Blade Removal

Steps for safely removing mower blades.

Blade Sharpening

Instructions for sharpening mower blades correctly.

Blade Resharpening

Blade Balancing

Blade Installation

End of Season & Long Term Storage

New Season Preparation

Section 6: Specifications & Capacities

Engine Specifications & Capacities

Hydrostatic Transaxle Specifications & Capacities

Section 8: Troubleshooting

Section 10: Warranty

Warranty

Land Pride ZT60i Specifications

General IconGeneral
Cutting Width60 inches
Blade Tip Speed18, 500 fpm
Turning RadiusZero-Turn
Cutting Height1.5" - 5.0"
Deck LiftManual

Related product manuals