What to do if my Landa PDE2-1100 Pressure Washer motor hums but doesn't run?
If your Landa Pressure Washer motor hums but doesn't run when switched on, it could be due to insufficient main voltage. Make sure the power supply is adequate. Alternatively, the pump may be stuck or frozen; try turning the motor manually to check.
Why is water dripping from the pump protector of my Landa PDE2-1100?
Water dripping from the pump protector of your Landa Pressure Washer may be due to a water supply pressure that is too high (over 90 psi). Use a regulator to lower the water supply pressure. It can also happen if the spray gun is in the off position for over 5 minutes; in this case, turn the machine off if it's not in use for more than 5 minutes.
Why is there water in the pump oil of my Landa Pressure Washer?
The presence of water in the pump oil of your Landa Pressure Washer could be due to a worn oil seal, high humidity in the air, or worn piston packing. Check these components and replace them if necessary.
Why is water dripping from under my Landa PDE2-1100 pump?
Water dripping from under the pump of your Landa Pressure Washer can be due to worn piston packing or a worn O-ring plunger retainer. Check these parts and replace if necessary.
Why does my Landa PDE2-1100 Pressure Washer motor keep stopping?
If your Landa Pressure Washer motor stops, it may be due to a tripped thermal overload caused by overheating. Ensure the main voltage matches the specifications for your unit. Wait a few minutes and then reset the GFCI cord to restart the machine.
Why is my Landa PDE2-1100 pump so noisy?
A noisy pump in your Landa Pressure Washer can stem from several causes. There might be air in the suction line, so check the water supply and connections. A broken or weak suction or delivery valve spring could also be the culprit. Foreign matter in the valves, worn bearings, or excessive water temperature (above 160°F) can also cause the pump to be noisy. Inspect and clean or replace the affected components.
What to do if my Landa PDE2-1100 Pressure Washer has low pressure after normal use?
If your Landa Pressure Washer's pressure is low after a period of normal use, the nozzle might be worn and needs replacement. Also, the suction or delivery valves could be worn, or the lines could be blocked, requiring cleaning. A worn unloader valve seat or worn piston packing could also cause low pressure. Furthermore, excessive water temperature could be the issue; reduce it to below 160°F. Check and replace parts as necessary.
General| Brand | Landa |
|---|---|
| Model | PDE2-1100 |
| Category | Pressure Washer |
| Language | English |
Highlights essential safety warnings and precautions for immediate attention.
Provides guidance on pre-rinsing, detergent application, and rinsing.
Outlines routine maintenance tasks and provides space for oil change records.
Detailed parts list for hose and spray gun components.
To Next Page
