10
Operations
Assembly Instructions
STEP 1: Attach a 5/8" water supply
hose to inlet connector. Minimum
flow should be 10 GPM depending
on model of machine.
STEP 4: Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
STEP 7: Check pump oil level by
using supplied dip-stick. Use SAE
10W-40 non-foaming only.
STEP 2: Attach high pressure hose
to discharge nipple using quick
coupler. Lock coupler securely by
pulling back coupler collar, inserting
onto discharge nipple and pushing
collar forward until secure.
STEP 5:
Before installing nozzle, turn
on water supply and run machine
allowing water to flush through the
system until clear. Pull the spring-
loaded collar of the wand coupler
collar back to insert your choice of
pressure nozzle.
CAUTION: Never
replace nozzles without engaging
the safety latch on the spray gun
trigger.
ATTENTION: Ne jamais remplacer
les buses sans d'abord mettre le
dispositif de sécurité sur la
détente du pistolet pulvérisateur.
STEP 8: Fill diesel tank.
STEP 3: Attach variable pressure
control wand to spray gun using
teflon tape on threads to prevent
leakage.
STEP 6: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
STEP 9: Install proper battery
making sure that the red cable is
attached to the positive terminal.
Use a 12V group 24 style battery.
Landa SLT/SLX Kubota Diesel Operator’s Manual 9.807-540.0 - E
High
Pressure
Hose
Discharge
Nipple
Collar
Trigger
Gun
Wand
Safety Latch
High
Pressure
Hose
Spray Gun
Pressure
Nozzle
Coupler
Collar
Coupler
Collar
Pressure
Nozzle
To Next Page
Loading...
