Landmann 12375 - User Manual

Questions and Answers

A
Anna HoustonAug 1, 2025
How to increase the temperature on my Landmann 12375?
- R
  Rachael McmillanAug 2, 2025
  If your Landmann Grill isn't reaching the desired temperature, consider these potential causes: * The pre-heating time might be too short. Close the lid and set the flame regulator to the maximum setting. * The gas outlets on the burner could be blocked. Clear any blockages from the burner. * The lava rocks may be piled on top of each other. Spread the lava rocks in a single layer, covering approximately 80% of the lava rock grill.
A
Alexandria SmithAug 7, 2025
What to do if there is a smell of gas coming from my Landmann Grill?
- A
  Amy HuntAug 7, 2025
  If you smell gas, it could indicate a leak in the gas system. Here's what to do: 1. Immediately close the cylinder valve by turning the operating lever to the 3 o'clock position. 2. Avoid any flames or sparks by not switching on electrical devices. 3. Tighten all gas system connections. 4. Inspect the gas system for damage, replacing any defective parts with original spares. 5. Use a leak detection agent to check for gas leaks.
J
Jerry HudsonAug 20, 2025
Why is there strong flaring up and burning of lava rocks in my Landmann 12375?
- S
  shannonbergAug 20, 2025
  If you notice strong flaring and burning of lava rocks in your Landmann Grill, it could be due to a couple of reasons: * The lava rocks might be dirty. To resolve this, operate the barbecue for about 10 minutes at full power with the lid closed (no food inside). * Fatty foods can also cause this issue. Remove large areas of fat from food before barbecuing, use a grill plate, or lower the barbecue temperature.
D
Dale SmithAug 26, 2025
What to do if my Landmann 12375 Grill is making a popping or bubbling noise?
- S
  Stacey JamesAug 26, 2025
  A popping or bubbling noise from your Landmann Grill indicates a flashback, often caused by blockages in the burner. To address this: 1. Immediately close the cylinder valve by turning the operating lever to the 3 o'clock position. 2. Wait three minutes, then restart the barbecue. 3. If the problem continues, remove and clean the burner.
F
Frederick ReyesNov 12, 2025
Why won't the burner light on my Landmann 12375?
- H
  halejustinNov 12, 2025
  If your Landmann Grill burner isn't lighting, several factors could be at play: * The gas cylinder might be empty, in which case you should replace it. * The cylinder valve could be closed; turn the operating lever to the 6 o'clock position. * The nozzles of the adjusting element might not be correctly inserted into the burner pipes; perform a visual check and align if needed. * The igniter cable may not be connected to the Piezo igniter; visually inspect and connect if necessary. * The distance between the spark plug and gas outlets on the burner could be incorrect; visually inspect and correct if needed. * The jet on the adjusting element might be blocked; remove the front panel and clean the jet with a pin. * Another part of the gas system could be blocked, requiring clea...