Laney CUB-SUPER12 - Page 4

CUB-RANGE
USER MANUAL
www.laney.co.uk
4
9 - BOOST LED - Indicates that the BOOST is engaged.
10 - INPUT SOCKET - Plug a good quality guitar lead in here.
11 - EXTERNAL SPEAKER. - Your CUB-SUPER10 is loaded with a HH Custom designed 8 Ohm Internal
speaker. Should you want to run an external speaker cabinet it can be connected here. Please use a
good quality SPEAKER cable. Connecting an external speaker cabinet will disconnect the internal
speaker. Please make sure you use the correct impedance of speaker cabinet from 8 - 16 Ohms.
12 - FX LOOP SEND - This is where you plug the INPUT of your Eect(s). Use a high quality shielded
guitar cable. This socket can also be used as a line out.
13 - FX LOOP RETURN - This is where you plug the OUT of your Eect(s). Use a high quality shielded
guitar cable.
14 - FOOTSWITCH SOCKET - This is where you plug in the footswitch. FS1-Mini optional extra. Enables
remote switching of the boost circuit. Ensure the boost switch (7) is switched in.
15 - POWER SOCKET - Plug in the supplied IEC power cord here
11
12
13
14
15
CUB-SUPER10 FEATURES