Laney RB2 - Page 8

7
4
11 12
13
14
10
9
8
6
7
5
Always switch off and disconnect power cord when not in use.
Sets the overall output level of the amplifier.
Controls the boost and cut of the low-frequency response of the pre-amplifier.
Para-Mid Level control cuts (anti-clockwise) or boosts (control clockwise) the frequency selected with the Para-
Mid frequency control (5).
Controls the boost and cut of the high-frequency response of the pre-amplifier.
AUX IN provided for connecting an external sound source such as; CD players, MP3 players etc.
Socket for connecting headphones. With headphones connected, the internal loudspeaker is automatically
switched off.
This socket provides a balanced low-impedance output-signal (Pre EQ) for connection to a mixing desk. Check
out the block diagram on page 9.
Para-Mid Frequency control selects the mid-frequencies (200Hz to 2KHz) to be cut or boosted with the Par-Mid
Level control (6).
Send and return sockets are provided for connecting external effects-units. You can also use the Send socket as a
line out if you wish. RB3 ONLY.
Indicates power is connected and the amplifier is switched on.