Laney RB3 User Manual

3 4
1
Page 8 /12 Page 9 /12
2
3
4
Power inlet socket. Connect to your power source. Make sure the specified voltage is correct for your country!
The main safety fuse for the unit is inside this drawer.
USE ONLY THE CORRECT SIZE AND RATING OF FUSE AS SPECIFIED ON THE PANEL.
The mains fuse ratings are detailed in the specs section at the rear of this manual.
Serial Number and model of your unit.
This socket(s) should be used to connect an extension-cabinet. The impedance of the extension-cabinet must not be less than
8 Ohms. Connecting cabinets that have a lower impedance than 8 Ohms will result in the amplifier overheating. Continual use
in this manner may cause permanent damage. Connecting a cabinet with an impedance of greater than 8 Ohms will cause no
damage to the amplifier but will result in a reduced output level. (When using an extension cabinet the internal speaker remains
connected)
Socket for connecting Headphones. When in use, the internal loudspeaker and any extension cabinets are automatically switched
off.
REAR PANEL CONTROLS
SAMPLE SYSTEM
8 Ohms
Link
Model RB115
Power Rating 300W Program
Model RB115
Power Rating 300W Program
Serial Number:Serial Number:
Input
Laney
Power To The Music
www.laney.co.uk
DESIGNED IN THE UK BY LANEY
8 Ohms
Link
Model RB115
Power Rating 300W Program
Model RB115
Power Rating 300W Program
Serial Number:Serial Number:
Input
Laney
Power To The Music
www.laney.co.uk
DESIGNED IN THE UK BY LANEY
SAMPLE
Input
Output
Loudspeaker Cable
BLOCK DIAGRAM
RB410
Laney
OPERATING INSTRUCTIONS
Laney
OPERATING INSTRUCTIONS
This loop is a series type so all
your signal will go through your
FX unit.
1
5
GAIN
ACTIVE
COMPRESSOR
SECTION
INTERNAL
LOUDSPEAKER
Headphones
EQ SECTION
POWER
AMP
VOLUME
FX LOOP
SEND RETURN
D.I.
2
5
INPUTS
NORMAL
HI
PAD
CD In

Laney RB3 Specifications

General

Brand	Laney
Model	RB3
Category	Amplifier
Language	English