www.Lanzar.com
5
PANEL LAYOUT
Front View
Rear View
CONTROL FUNCTIONS
1. RCA input jacks
These RCA input jacks are for use with source units that have RCA or Line level
outputs. A source unit with a minimum level of 200mV is required for proper
operation. The use of high quality twisted pair cables is recommended to
decrease the possibility of radiated noise entering the system.
2. GAIN Control
The level control will match the ampliers sensitivity to the source units signal
voltage. The Operating range is 200mV minimum to 6V maximum.
CAUTION: Do not run the amplier in high volume for long time, otherwise
the loudspeakers will be damaged.
3. SUBSONIC
The frequency can be adjusted between 0Hz and 80Hz.
To Next Page
Loading...
