owner’s manual
troubleshooting
If you experience....
Check that:
Level of sound is low.
• Wiring is not loose or cables
misconnected/disconnected
• RCA cables are not faulty.
Background noise is
too high.
• Wiring is not loose or cables
misconnected/disconnected
• RCA cables are not faulty.
20
Signal Processor does not
turn on.
• Remote Turn-On wire has 12V
• 12V wire has 12V
• Ground wire is properly connected
precautions
• Never drive with the volume raised so high you cannot hear what is occuring in traffic
around you.
• Be aware that repeated exposure to excessive volume levels can permanently damage
your hearing!
• Keep all electronics away from moisture, dust, extreme heat or extreme vibrations.
• Lanzar Audio products are capable of sound pressure levels in excess of 150 dB.
Continuous exposure to sound pressure levels over 100 dB may cause permanent
loss of hearing. Use common sense and PRACTICE SAFE SOUND.
Enjoy your system, but use it wisely and safely!
signal processors
To Next Page
Loading...
