Laresar Evol 3 - Preparation; Initial Setup and Precautions; Operational Restrictions and Safety

If you have any questions please email to support09@laresar.us
12
EN
If you have any questions please email to support09@laresar.us
13
EN
5.Preparation
Precautions
• Before starting the vacuum cleaner, clean up wires and sundries scattered on the ground, and remove easy-to-fall,
fragile, valuable and potentially dangerous items. Avoid being entangled, jammed, dragged, or knocked down by the
robot; otherwise, personal or property damage may be caused.
• Do not use the robot to vacuum liquid. otherwise it will
damage the fan and affect the performance of the robot.
• When used in a suspended circumstance, it shall be
protected by rails to avoid accidental falling or pushing
other articles from falling.
1.Remove the protection material from both sides of the robot
2.Install side brushes
• Put the left brush (L) and right brush (R) against the letters L and R on the bottom respectively; move down for “click”
to finish installation.