The VISO II can be customised to your personal settings. Your settings will be stored
and recalled also after replacing batteries. When you first get the VISO II, we recom-
mend you to go through the SETUP Selector to customise the VISO II settings.
SETUP Selector
In the Setup Area the following options can be selected:
• Alti-Meter/ Speed-Meter
• Feet/ Meter when set to Alti-Meter
• Mph/ Kmh when set to Speed-Meter
• Altitude offset
• Dive Type
• True Airspeed (TAS) / Skydiver’s Airspeed (SAS)
• Set current year
• Set current date
• Set current time
VISO II Settings
It is recommended that you first familiarize yourself with the VISO II
ROAD MAP which is a very helpful tool when using the VISO II for the first time.
The ROAD MAP comprises four areas:
• Backlight Setup Area (see page 39)
• Prole Area (see page 51)
• Setup Area (see page 19)
• Logbook Area (see page 43)
Road Map
General note:
The VISO II goes out of ACCESS and back to the Main Window if no button has been
pressed within 15 sec.
ALL functions (except Power ON) can be performed ONLY when the VISO II is in ACCESS mode.
To leave the Setup Area
Wait until the display times out, or press repeatedly until the Padlock window
shows. Then press or to exit.
VISO II Settings
Padlock Window
• Preset jump counter
• Reset jump counter
• Turn the VISOII OFF
• Padlock window
To enter the Setup Area
Perform ACCESS on or . Then hold > 5 seconds
Performing ACCESS:
1 Press or and release quickly. The padlock icon turns ON and OFF
2 When the padlock icon turns ON again, immediately press the same button and
keep it pressed (padlock turns OFF)
3 When the padlock icon turns ON again, release immediately
VISO II Settings
Feet/Meter Selector
Alti-Meter/ Speed-Meter • Feet/Meter when set to Alti-Meter • Mph/ Kmh when set to Speed-Meter • Altitude
offset • Dive Type • True Airspeed (TAS)/ Skydiver’s Airspeed (SAS) • Set current year • Set current date • Set
current time • Preset jump counter • Reset jump counter • Turn the VISOII OFF• Padlock window
Feet/Meter
VISO II Settings
Press or to toggle between Feet/Meter.
The active selection flashes.
Press to save setting and enter the Mph/Kmh selector.
Note: Jump data is continuously stored in both feet and meter.
At any time stored information may be displayed in either unit
of measurement by selecting the respective mode.
Alti-Meter / Speed-Meter Selector
Alti-Meter/Speed-Meter • Feet/ Meter when set t o Alti-Meter • Mph/ Kmh when set to Speed-Meter • Altitude
offset • Dive Type • True Airspeed (TAS)/ Skydiver’s Airspeed (SAS) • Set current year • Set current date • Set
current time • Preset jump counter • Reset jump counter • Turn the VISOII OFF• Padlock window
Alti-Meter / Speed-Meter
The VISO II can be set to function either as an Alti-Meter or as a Speed-Meter.
VISO II Settings
Press or to toggle between Alti-Meter or Speed-Meter
mode.
The active selection flashes.
Press to save setting and enter the Feet/Meter selector.
To Next Page
Loading...
Need help?
General
