MAINTENANCE
WHEEL MAINTENANCE
With time, the wheels can wear down or become damaged, particularly
when used on rough surfaces. The back wheel, where the brake applies
pressure, is especially affected. The wheels should be checked regularly for
signs of wear, and replaced if necessary.
14 15
REMOVE OR CHANGE COLLAR CLAMP
1. Loosen both screws as indicated in the diagram.
2. Pull the collar clamp upwards to remove it.
3. After replacing the collar clamp, tighten the screws
as shown.
REPLACING THE MAGNET ON THE LIGHT UP WHEELS MECHANISM
Please Note: The lights on this product work for a limited time. However, you
can replace the mechanism so you can enjoy your scooter to the max once
again! Please contact us and we will send you a complimentary replacment
magnet which can be used to replace the magnet in your wheels. This magnet
produces the lights in the wheels. Follow the simple and quick instructions
below to replace the magnet.
To install the replacement magnet, First, remove the center screw of the wheel
by turning it. The wheel will detach itself from the base.
LEFT WHEEL: To remove the left wheel, sue the
Allen key to run the screw COUNTER-CLOCKWISE.
RIGHT WHEEL: To remove the right wheel, sue the
Allen key to turn the screw CLOCKWISE.
DECK REPLACEMENT
Check deck for a tight fit after riding about 3
miles.
1. Loosen all 6 screws indicated in the diagram.
2. Replace deck and tighten all screws.
Step 1: With the Allen key provided in the
package of the scooter, remove the red
screw. As shown (Figure A and B), The
magnet will now be visible.
Step 2: Remove the magnet (Figure C),
Replace it with your new magnet, cover
it with the red screw and close it by
turning the center screw (Figure D).
B C DA
To Next Page
Loading...