Laser STB-6000 User Manual

STB-6000 USER MANUAL
20
Due to the power requirements of some USB drives, the USB port on this device may not be
able to power the drive.
Please ensure that the drive is formatted in FAT32 or NTFS before recording.
TROUBLE SHOOTING
Problem
Possible Cause
Solution
No Picture Power is not connected
Connect the power and
make sure unit is turned on.
Screen Shows “No Signal”
Antenna cable is not
connected
Check the antenna
connection to the rear of the STB
No sound
No or incorrect audio cable
connections
Check connections of audio cables
Sound is muted Un-Mute audio
No picture but sound OK
No or incorrect Video cable
connections
Make sure cables are connected
correctly.
Remote Control is not
responding
Batteries are flat Replace.
Picture is breaking up Signal is too weak Check antenna connection.
USB device is not detected Not powered correctly
Check power source (if fitted) or
reconnect.
Movie Payback out of sync
Faulty file
Check file to ensure not encoding
issue
File to large for STB
Re-encode file at lower resolution
and/or data rate
SPECIFICATIONS
TECHNICAL SPECIFICATIONS
TUNER
INPUT FREQUENCY
170~230MHz
471~860MHZ
RF INPUT LEVEL
-
25~
-
82DbM
IF BANDWITCH
7MHz & 8MHz
MODULATION
QPSK, 16QAMM 64QAM
VIDEO
DECODER FORMAT
MPEG4 AVC/H.264 HP@L4
MPEG2 MP@ML.HL
OUTPUT FORMAT
576p, 720p, 1080i, 4:3 & 16:9
OUTPUT PORT
HDMI (V1.3C) YpBpR, cvbs
AUDIO
DECODER FORMAT
MPEG
-
1 (layer 1&2&3) WMA, AC3
AUDIO OUTPUT
2 X RCA (L/R), COAXIAL SPDIF
USB 2.0
SUPPORTTED CAPACITY
750GB
SUPPORTED MEDIA
MP3, WMA, JPEG, BMP, AVI, MKV
POWER
SUPPLY VOLTAGE
100~240VAC 50/60Hz
MAXIMUM POWER CONSUMPTION
8W
STANDBY POWER CONSUMPTION
< 1W

Laser STB-6000 Specifications

General

Brand	Laser
Model	STB-6000
Category	Set-top boxes
Language	English