6
OPTIONAL TAMPER DETECTION
SEAT SENSOR/SIDE PANEL, ETC.
Arm the alarm by remote control; The LED will be constantly on, releasing the seat/side panel, etc. will
cause the LED to blink off for 1 second indicating that detection occurred. Note: A connecting
cable from the alarm may be attached to the base of the seat/side panel. This cable
has a connector to allow removal of seat/side panel and should always be recon-
nected when the seat/side panel is refitted. Failure to reconnect will mean the alarm
will not sense the seat/side panel being released. Ensure the seat catch/side panel
mount is kept clean and free from dirt and grease. When refitting seat/side panel,
ensure cable is not trapped or damaged. If the cable is not reconnected to the seat/
side panel the alarm will still operate normally except no detection of the seat/side
panel being released will occur.
SIDE STAND SWITCH
Arm the alarm by remote control; The LED will be constantly ON, releasing the side stand
will cause the LED to blink OFF for 1 second indicating that detection occurred.
GARAGE MAGNETIC/INFRA-RED SENSOR/S
Arm the alarm by remote control; The LED will be constantly ON, moving the magnet from
the contact switch/create body movement within the range of the infra-red sensor will cau-
se the LED to blink OFF for 1 second indicating that detection occurred.
NOTE: Every time the magnetic contact or the infra-red sensor sends an alarm signal, the
red LED on the sensor lights for 2 seconds. The sensors have a battery saving function.
After an alarm signal as been transmitted to the alarm by a sensor, the sensor is inhibited
for 30 seconds and it must not detect any variations (keep still or move away from the pro-
tected area), otherwise this time will be extended and the sensor will not emit any alarm
signal until a least 30 seconds have past without detecting.
To Next Page
Loading...
