11
Safety instructions
Do not climb on the frame when it is be-
ing adjusted and when it is raised.
The frame is designed so that it normally
poses no risk of getting clamped or
crushed during operation. Even so,
please make sure that there is nobody,
in particular no child, under the frame
or in a position to reach into the mecha-
nism when raising or lowering the frame.
Lattoflex 282 to 984 are inlay frames
for bed structures. They are only intend-
ed for use according to the conditions
stated in these instructions and only for
domestic use.
Make sure that the cables are never
clamped, placed over sharp edges or
crushed between moving parts of the
frame. Only use original parts to replace
damaged connection leads. Shortening
the support beams or dismantling attach-
ment parts poses a risk of damage.
Do not store any items under the frame.
Bedding in particular can be damaged by
the motors.
Cleaning and care
Your Lattoflex spring base does not need
any special care. Simply wipe it down
from time to time with a damp cloth.
Please do not use any solvents or benzene,
or any caustic or scouring cleaning
agents! Always take the mains plug out
of the socket before cleaning.
Use silicone or preferably Flonium to
treat any noises coming from the running
surfaces of the sliding function or plastic
bearings. Never use commercially
available oil or grease.
Special function default setting:
Radio remote control:
Hold and press these 3 buttons (head/
back/calf down) until the status LED
lights up and stays on.
Control box:
Press and hold the button for approx.
10 seconds until the white LED lights up
once. There are now no longer any
remote controls connected to the frame.
To Next Page
Loading...