Need help?Do you have a question about the Lauda Integral T 1200 and is the answer not in the manual?
General| Temperature Stability | ±0.01°C |
|---|---|
| Control Type | Digital |
| Display | LCD |
| Pump Flow Max./Rate | 15 L/min |
| Cooling Output at 20°C | 1.2 kW |
| Circulation Pump | Pressure pump |
| Power Supply | 230 V; 50 Hz |
Essential safety guidelines for equipment operation, handling, and maintenance.
General safety guidelines for using the LAUDA process thermostat, covering hazards and user responsibilities.
Specific safety advice for operation, maintenance, and handling of the LAUDA process thermostat.
Details on compliance with EU directives for health, safety, and electromagnetic compatibility.
Operating conditions for LAUDA process thermostats, including altitude, humidity, and temperature limits.
Classification and naming convention for LAUDA Integral T process thermostats.
Explanation of how the heating/cooling circulation thermostats function with a small bath volume.
Description of the bath, immersion pump, and associated components within the thermostat unit.
Materials used for components in contact with heat transfer liquid.
Details on the sealed compressor, heat exchanger, and refrigerant system of the thermostat.
Description of the control unit, display, keys, and safety circuit functions.
Description of the various connectors for standby, alarm, analog, and serial interfaces.
Details on optional features like enlarged temperature range, high-power pump, flow control, and low-pressure pump.
Instructions for physically positioning and setting up the thermostat unit for operation.
Procedure for filling the bath with liquid and connecting the external circuit.
Instructions on how to safely drain the heat transfer liquid from the equipment.
Approved heat transfer liquids, their properties, and recommended usage for different temperature ranges.
Requirements for cooling water purity to prevent corrosion and damage to the system.
Specifications and types of hoses suitable for connecting the thermostat to external circuits.
Instructions for connecting the thermostat to the electrical supply, including safety checks.
Procedure for switching on the thermostat, including initial settings and self-test.
Overview of key functions, general operation, and key inhibit features.
Diagram illustrating the navigation between menu levels and functions.
Description of standby mode and external control configuration options.
Functionality for creating, storing, and running temperature-time programs.
Accessing and modifying various operational parameters like interfaces, start modes, and limits.
Configuration of analogue inputs and outputs for external signal integration.
Adjusting control parameters for internal and external control modes.
Details on connecting and testing the RS 232 serial interface for communication.
Connecting cables and protocol for the RS 485 serial interface.
List of commands for writing data and parameters to the thermostat.
List of commands for reading status and measurement data from the thermostat.
How to set and test the overtemperature protection mechanism and its response.
Procedure for testing the low-level liquid protection and the unit's response.
Monitoring for pump motor overload or blockage and related fault indications.
Table of error codes and their corresponding explanations for troubleshooting.
Instructions for cleaning the exterior of the thermostat unit using water and mild detergent.
Guidelines for performing maintenance and repairs, emphasizing safety and qualified personnel.
Table detailing recommended servicing intervals for various system parts.
Recommendations for checking and renewing the heat transfer liquid for optimal performance.
Information on protective devices like overcurrent cut-outs and fuses.
Step-by-step guide on how to safely remove the control unit from the thermostat.
Instructions for cleaning condensers and decalcifying cooling water circuits.
Guidelines for the disposal of the device, refrigerant, and packaging according to EU directives.
Contact information for technical service and procedures for ordering spare parts.
To Next Page
