To Next Page

To Previous Page

09/2020 Puridest Glass Distillation Apparatus 31 / 34

Pre-Filter 1 µm, for pre-cleaning the tap water, and to protect the unit from premature contamination. Complete with

connections for pressure hose ½" (inner diameter 12.7 mm), including filter candle. The candle should be replaced at least

every six months.

Pre-Filter with candle Spare candle

Part-No. A000133 Part-No. A000134

Wall bracket, for one filter or for filter combinations of two or three filters, including sleeves to connect the filters as well as

screws to fix the filters to the wall bracket.

A data sheet on possible connection variants of articles A000129, A000131 and A000133 can be supplied on request.

Set of all 3 filters, incl. wall bracket

Wall bracket for one filter and fillings, mounted completely

Part-No. A000136 Part-No. A000135

Hose Sets, consisting of hoses for water inlet and outlet (length 1.5 m), including hose clips.

Hose Set

Hose Set for models PD 2G to PD 8 G

for models PD 2 G to PD 8 G for seperate water supply

Part-No. A000139 Part-No. A000143

Hose Set

Hose Set for models PD 2 DG and PD 4 DG

for models PD 2 DG and PD 4 DG for seperate water supply

Part-No. A000140 Part-No. A000144

Level Control Switch

Only factory installation into all Glass Distillation Apparatus is possible.

When connecting an external storage tank (not included in the scope of supply) to the Distillation Apparatus, it is recom-

mended to equip the unit with a Level Control Switch which controls the water level in the external storage tank and

switches off power and water when the external storage tank is full. When using an external storage tank in connection

with Level Control Switch, the internal storage tank is only usable to a limited extent due to different levels of the internal

and external tanks. Part-No. is depending on the Model of the Distillation Apparatus.

Level Control Switch

Lauda PD 2 G User Manual

Questions and Answers: