LAUNCH TECH X-431 PRO V4.0 - 5. How to do if the system runs slow?; 6. How to reset the tablet?

LAUNCH
X-431 PRO V4.0 User Manual
54
3. After activation completed, tap “Personal Center” -> “My Connector” to
check if the activated VCI device is displayed in the connector list or not
.
Multiple VCI devices can be bound to one tool. If you intend to use one of
the VCI devices to diagnose or test a vehicle, just switch to the
corresponding VCI device.
5
. Ho
w to do if the system runs slow?
In
this case, please do the followings:
> Check all running applications and stop the unnecessary applications (Steps:
Settings --> Apps --> Running --> Tap the desired application and then tap
“Stop”).
> Check all installed applications, remove the unnecessary applications (Steps:
Settings --> Apps --> Downloaded --> Tap the desired application and then tap
“Uninstall”).
If all steps mentioned above are finished and the system still works slowly.
Please try to close the system and reboot the tablet.
6
. Ho
w to reset the tablet?
R
esetting may cause data loss. Before doing so, please make sure important data
and information has been backed up.
Do the following to reset the tablet:
1. Tap “Settings” --> “Back & Reset”.
2. Tap “Factory data reset”.
3. Tap “Reset tablet”.
4. Tap “Clear all data” to start resetting until the tool automatically reboots.