29
LAUNCH
User Manual
EN
8. Settings
8.1 Units of measurement
It is designed to set the measurement unit. Metric System and English System
are available.
8.2 Automatic detection on connect
This option enables you to determine whether to start an automatic VIN detection
once the tool is properly connected to the vehicle’s DLC.
8.3 Display & Brightness
This item allows you to set the standby time and screen brightness.
*Tips: ZeĚucinŐ the ďƌiŐhtness of the scƌeen is helpful to conseƌǀe the poǁeƌ of the
hanĚset
8.4 Sound
This option lets you adjust the volume and other sound settings.
8.5 Network
*Note: Knce t>N is set as KN the tool ǁill consuŵe ŵoƌe poǁeƌ thile it Ŭeeps
unuseĚ please set it oī to saǀe poǁeƌ thile t>N Ŭeeps unuseĚ please tuƌn it oī
to conseƌǀe ďaƩeƌy poǁeƌ
The tool has built-in WLAN module that can be used to get online. Once you’re
online, you can register your tool, update diagnostic software & APK, send email
on your network.
Slide the switch to ON, the system starts searching for all available wireless
LANs. Choose the desired WLAN access point / network to connect.
8.6 Date/Time
This option allows you to set the system date & time.
*Note: ^ince all ĚiaŐnostic ƌepoƌts aƌe soƌteĚ ďy DaŬe anĚ ate To Ěiffeƌentiate
ďetǁeen Įles please conĮŐuƌe the accuƌate systeŵ Ɵŵe
To Next Page
Loading...
