LAUNCH Smartbox 3.0-J2534 Operation Manual
11 / 15
Step 1: Open the configuration tool "SmartBoxTool":
Step 2: Click "View Log" in the upper left corner of the screen. It is in USB to Ethernet
Adapter mode now. For USB bulk transfers, it is necessary to set the communication method from
"USB to Ethernet Adapter" to "USB". Click "Setup".
Step 3: The setup is successful, as shown below:
Close the tool and re-power Smartbox3.0;
Check whether the USB device is recognized in the device manager of the computer. If yes, the
setup is successful, as shown below:
To Next Page
Loading...
Need help?
General
